Installation:
   Installing Command Post is simple. Just send it to your calculator using TI Graphlink or TI Connect. The Cmdpost.89k is for the TI-89; Cmdpost.9xk is for the TI-92 Plus and V200 calculators. Next follow any popup dialogs that Command Post may show on the screen. Currently, you will need about 32K of free flash memory and about 1K of ram for Command Post to install successfully. Command Post requires AMS 2.05 or better to install. If AMS 2.05 is not present, then Command Post will not be installed and you will not be able to use it.

If you are prompted to uninstall a kernel or kernel like program such as PreOS or KerNO, follow the directions. This will allow Command Post to make sure that it integrates correctly with the operating system. Once Command Post has performed its installation tasks successfully, it will display a dialog after you remove the kernel telling you that you may reinstall the kernel if you want to.

Removal:
   To remove Command Post from your calculator, bring up the Var-Link Screen (2nd Var-Link). Press F7, select Command Post from the list of install FLASH APPS, and then Select F1->1: Delete. Command Post will try to automatically uninstall the leak watch hooks if you have any installed, and it will attempt to remove its anti-crash protection.

If a dialog is displayed telling you that command post cannot be removed, you should follow the suggestions given. If the dialog tells you that you need to uninstall a kernel that was installed after command post, do it! Once Command Post has been successfully removed, you can reinstall the kernel.

Also, make sure that no applications have leak watch installed on them, or Command Post may refuse to uninstall.